Howdy, Stranger!
We are about to switch to a new forum software. Until then we have removed the registration on this forum.
Categories
- All Categories 25.7K
- Announcements & Guidelines 13
- Common Questions 30
- Using Processing 22.1K
- Programming Questions 12.2K
- Questions about Code 6.4K
- How To... 4.2K
- Hello Processing 72
- GLSL / Shaders 292
- Library Questions 4K
- Hardware, Integration & Other Languages 2.7K
- Kinect 668
- Arduino 1K
- Raspberry PI 188
- Questions about Modes 2K
- Android Mode 1.3K
- JavaScript Mode 413
- Python Mode 205
- Questions about Tools 100
- Espanol 5
- Developing Processing 548
- Create & Announce Libraries 211
- Create & Announce Modes 19
- Create & Announce Tools 29
- Summer of Code 2018 93
- Rails Girls Summer of Code 2017 3
- Summer of Code 2017 49
- Summer of Code 2016 4
- Summer of Code 2015 40
- Summer of Code 2014 22
- p5.js 1.6K
- p5.js Programming Questions 947
- p5.js Library Questions 315
- p5.js Development Questions 31
- General 1.4K
- Events & Opportunities 288
- General Discussion 365
Help with Device Connections on Nano v. 3
I am using Processing 2.0.3 and the Arduino boards as discussed below. When I use my Uno board and print out the Arduino.list(), I get these devices:
[0] "/dev/tty.Bluetooth-Serial-1" [1] "/dev/cu.Bluetooth-Serial-1" [2] "/dev/tty.Bluetooth-Serial-2" [3] "/dev/cu.Bluetooth-Serial-2" [4] "/dev/tty.Bluetooth-Modem" [5] "/dev/cu.Bluetooth-Modem" [6] "/dev/tty.Bluetooth-PDA-Sync" [7] "/dev/cu.Bluetooth-PDA-Sync" [8] "/dev/tty.usbmodem14221" [9] "/dev/cu.usbmodem14221"
I can set my Arduino object to list item [8] and my program works fine.
However, when I switch to the Nano v. 3 board and list my devices, I get this:
[0] "/dev/tty.Bluetooth-Serial-1" [1] "/dev/cu.Bluetooth-Serial-1" [2] "/dev/tty.Bluetooth-Serial-2" [3] "/dev/cu.Bluetooth-Serial-2" [4] "/dev/tty.Bluetooth-Modem" [5] "/dev/cu.Bluetooth-Modem" [6] "/dev/tty.Bluetooth-PDA-Sync" [7] "/dev/cu.Bluetooth-PDA-Sync" Experimental: JNI_OnLoad called.
There is no "dev/tty.usbmodem14221" listed and so my sketch does not work.
Can anyone shed light on why I'm not showing the device I need?
MacMini, OS X 10.8.5.