Processing Forum

Loading...

Processing Forum

Screen name:
lee1972

lee1972's Profile

2 Posts

3 Responses

0 Followers

Activity Trend

Last 30 days

Loading Chart...

Show:

Expanded view
List view

can I use processing.net library if I have a peer to peer network to set up.

[0 Replies]
- 17-Jan-2012 03:03 AM
- Forum: Integration and Hardware
Hi all,

I have a device that has the following ethernet interface:-

The Ethernet interface has a data transmission rate of 10 MBaud (10Base
E T). The interfaceis a TCP/IP peer to peer interface. Only half duplex is supported. Please ensure that the interface of your application is set to half duplex.The factory setting for the Ethernet interface is as follows:

•
IP ADDRESS: 192.168.0.4
• TCP/IP PORT: 2111

•
SUBNET MASK: 255.255.255.0

Can I use processing.net library to communicate with the device or is there another library that supports peer to peer network (no need for a server)? Or any suggestions?

Thanks in advance.

trying to communicate with a SICK LMS400 laser scanner via its ethernet connection.

[6 Replies]
- 30-Dec-2011 04:29 AM
- Forum: Integration and Hardware
As anyone done this? I'm using the network library.I made the scanner a client with ip address 192.168.0.4 TCP port =2111. To measure continuously from scanner you must write the command sMN Rreqdata 21 where sMN.. is a string and 21 is an uint. i noticed uint is not a valid datatype in processing. Could this be my problem? To overcome this I made two bytes as follows:-

btye a=0;

btye b=21;

.

.

myClient.write("sMN Rreqdata" + a + b); //this line should start scanner measuring but it doesn't

i have pinged scanner and it is ok

i can send my code if it helps?

I hope somone can advise?

«Prev
Next »